Brondell FS-10 Installation Guide download pdf (Page 5)

2) Turn o water supply valve and

ush toilet

a. Turn o water supply at the wall to

stop ow of water.

b. Flush toilet and hold down handle

to completely empty toilet tank.

c. Disconnect water supply hose from

water shut o valve. You may have

to use a 3/8’’ compatible wrench or a

similar tool if the connection is tight

(not supplied).

3) Connect T-valve to supply line

Note: Do not connect FreshSpa to

hot water line. Only connect to a cold

water pipe.

a. Install the T-valve and the small

rubber washer onto the water shut

o valve coming out of the wall.

b. Connect the water supply line to

the open end of the T-valve using the

second small rubber washer (if needed).

4) Connect the Bidet Hose to the T-valve

a. Connect one end of the bidet hose to

the remaining open side of the T-valve.

5) Install Bidet Attachment on Toilet

a. Place large rubber washers over the

open bolt holes in the toilet xture.

b. Place bidet attachment over

washers so the nozzle is as close to

the back of the toilet bowl as it will go.

This will vary by toilet.

c. Make sure the adjustable brackets

line up with the holes in the toilet

xture. You may need to move the

adjustable brackets accordingly to

line up properly.

d. Replace the toilet seat on top of

bidet attachment and secure using

original toilet seat hardware. Make

sure to tighten so that the bidet

attachment and seat do not move.

Step 2a

Step 4a

Step 5

Step 2c

Step 3a & 3b

Installation Installation

6 7

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments